Packet tracer which end is dce

With a back-to-back serial connection, the ISR router connected to the DCE end of the serial cable provides the clock signal for the serial link. This clock is received by the DTE device. The clock rate command in the interface configuration mode enables the router at the DCE end of the cable to provide the clock signal for the serial link. The default clock rate is You can connect to the routers using CLI. The encapsulation ppp configures PPP protocol on the serial interface.

PPP authenication can be oprtionnally configured using the following IOS commands which are not used in this lab :. Router-B beeing the DCE side of the serial link, the Don't forget to enable the interface with a no shutdown command. The link becomes up as both routers are correctly configured.

All Answers. Another thread that might help with the CSU DSU Explaination - Sorry about all the information - Hope it helps please correct if I explain something wrong or overly complicated anything. Regards, Adrian. Dear Mustafiz, You need a sereil cable V.

Last, flip the cable and run the commands again. That was so Helpful thanks guys.. Correct me if went wrong thanks Message was edited by: Mustafiz. Mustafiz, The above link gives a really good amount of images that really explain a wan set up. Here is the image of it all together: Hopefully this will shed some light! Thanks i got my answer for that Mustafiz, Im sure theres more to the reasoning behind it that I know of, but my understanding is that if you dont have IP addressing over WAN, then the routing won't work between devices.

Hope this helps, Adrian [Please add to this if I've missed something or didnt explain it properly, as it would benefit me also]. Got it Adrian thanks. Thanks very much. Hi Amir, If both are Down Down, then there should be a layer1 issue. Log In to Answer. Related Questions Nothing found. More locations. More flexibility. Follow Us. Certifications Help About Us. As mentioned in the above post, there is also an interface sub-command available; bandwidth. The above formula is to calculate cost for any given outgoing interface to reach any particular subnet in a route.

The OSPF formula can be a little confusing. Go back to Tutorial. Bandwidth and Clock Rate on Serial Interfaces. Get industry recognized certification — Contact us Please enable JavaScript in your browser to complete this form.

Contact no.